Dji Ace Waypoint Manuel d'utilisateur télécharger pdf (Page 20)

B11 Camera Gimbal Control

This function aims to auto balance the 2-D camera gimbal. Roll direction of the gimbal is fully automatic controlled by Ace Waypoint,

Pitch direction is automatic controlled by Ace Waypoint with real-time manual adjustment support.

In Assistant Software, page - Gimbal:

STEP1: Servo travel limit and center position

Range: -1000 to +1000

MAX / MIN are servo travel limits; adjust them to avoid

mechanical binding; Place your helicopter on level

ground, adjust CENTER value of PITCH and ROLL

direction to make the camera mounting frame to your

desired angle-to-ground.

Roll

Pitch

STEP2: Direction & Automatic control gain Range: 0 to 100

Adjust the reaction angle of automatic control, the initial

value 100 is full speed；Click / button, and then

you can reverse the feedback control directions.

STEP3: Manual control command for Pitch direction of the gimbal.

You should assign one of the knobs on your transmitter to

X1 channel for controlling the Pitch direction (angle) of

camera gimbal during flight.

knob

If parameter adjustment was enabled on channel X1, the

gimbal manual control via channel X1 will not be force to

disabled.

STEP4: Manual Control Speed Range: 0 to 100

Adjust the reaction speed of pitch direction manual

control, the initial value 100 is full speed.

STEP1

STEP2

STEP4

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Dji Ace Waypoint Manuel d'utilisateur Page 20